-
Oil Seal
Oil seals are used to seal around a rotating shaft and keep an oil-based lubricant inside an axle, engine, etc.
-
D-ring
D-rings are often used as an alternative to o-rings in reciprocating dynamic applications because of their resistance to spiral failure.They can be used for sealing on the ID or the OD. -
-
V-rings
V-rings are installed on a rotating shaft and seal axially against the counter-face. V-rings are typically used to supplement other seals by serving as deflectors or by creating a labyrinth for contaminants.
-
X-ring
X-rings can be used as an alternative to o-rings in dynamic applications because of their reduced friction and their resistance to spiral failure
-
Square Rings
Square rings can be either molded or lathe-cut. The lathe-cut parts are often less expensive than comparably sized o-rings, especially forlarger IDs.
-
O-Ring Cross-Section Gaskets
For face-type applications, the o-ring cross-section can be applied to non-circular openings or even when multiple openings require sealing. These sometimes are known as press-in-place gaskets
-
O-Ring Cord and Spliced O-Rings
O-ring cord can be supplied in bulk or spliced into O-rings of any ID.Spliced O-rings can be a convenient and cost-effective alternative to molded O-rings when large ID’s, small quantities or low compression set is required.
Cord and spliced O-rings are available in a variety of cross-sections and materials.
-
FEP Encapsulated O-Rings
FEP encapsulated o-rings are used in harsh chemical environments or with extreme temperatures. They offer excellent sealing capabilities at a fraction of the cost of perfluoroelastomer O-rings. Hanoja offers FEP encapsulated silicone and FKM O-rings.